AudioCodes MEDIAPACK VERSION 6.2 Bedienungsanleitung PDF herunterladen (Seite 33)

CTM; Reviewed:

SPOC 11/29/2007

Solution & Interoperability Test Lab Application Notes

33 of 51

AudioCodesMP118.doc

Step Description

13.

Supplementary Services

From the menu shown in Step 11, navigate to Advanced Parameters Æ

Supplementary Services. Configure the parameters as described below.

 If the analog phones connected to the MP-118 support Caller ID then set the

Enable Caller ID field to Enabled. For the compliance test, this field was set

to Disabled since none of the analog phones used had a Caller ID display.

Caller ID can also be controlled on a per port basis by navigating to Protocol

Management Æ Endpoint Settings Æ Generate Caller ID to Tel Table (not

shown here).

 Select Enabled for the Enable MWI and MWI Display fields if the analog

phones support a visual MWI indicator. For the compliance test, even though

these fields were enabled, MWI was only tested for stutter dial tone.

 Hold, Transfer, Call Forwarding and Call Waiting are enabled by default.

Default values may be retained for all other fields. Scroll down to the bottom of the

page and click Submit (not shown).

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 50 51

Keine Kommentare

AudioCodes MEDIAPACK VERSION 6.2 Bedienungsanleitung Seite 33