AudioCodes Mediant 600 Installationshandbuch

Stöbern Sie online oder laden Sie Installationshandbuch nach Gateways / Controller AudioCodes Mediant 600 herunter. AudioCodes Mediant 600 Installation manual Benutzerhandbuch

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken

Inhaltsverzeichnis

Seite 1 - Installation Manual

Document #: LTRT-85605 February 2010 Installation Manual Version 6.0

Seite 2

Installation Manual 10 Document #: LTRT-85605 Mediant 600 Reader’s Notes

Seite 3 - Table of Contents

Version 6.0 11 February 2010 Installation Manual 2. Installing the Device 2 Installing the Device This section describes the device's hardw

Seite 4 - List of Figures

Installation Manual 12 Document #: LTRT-85605 Mediant 600 2.1.1 Front Panel The device’s front panel is shown in the figure below and described i

Seite 5 - List of Tables

Version 6.0 13 February 2010 Installation Manual 2. Installing the Device Item # Label Component Description Enlarged View of CPU (#3) 4 I Dry

Seite 6

Installation Manual 14 Document #: LTRT-85605 Mediant 600 2.2 Unpacking and Checking Package Contents Follow the procedure below for unpacking th

Seite 7 - Customer Support

Version 6.0 15 February 2010 Installation Manual 2. Installing the Device ¾ To stick the anti-slide rubber bumpers to the device: 1. Flip the d

Seite 8 - Caution Electrical Shock

Installation Manual 16 Document #: LTRT-85605 Mediant 600 2.3.2 19-Inch Rack Mounting The device can be installed in a standard 19-inch rack. Bef

Seite 9 - 1 Introduction

Version 6.0 17 February 2010 Installation Manual 2. Installing the Device 2.4 Cabling the Device This section describes the cabling of the devic

Seite 10 - Reader’s Notes

Installation Manual 18 Document #: LTRT-85605 Mediant 600 2.4.1 Connecting to Earth (Ground) The device must be permanently connected to earth (g

Seite 11 - 2 Installing the Device

Version 6.0 19 February 2010 Installation Manual 2. Installing the Device 2.4.3 Connecting to E1/T1 Trunks The device supports up to two E1/T1 t

Seite 13 - 2.1.2 Rear Panel

Installation Manual 20 Document #: LTRT-85605 Mediant 600 2.4.4 Connecting E1/T1 Trunks for PSTN Fallback The device offers a PSTN Fallback featu

Seite 14 - 2.3 Mounting the Device

Version 6.0 21 February 2010 Installation Manual 2. Installing the Device ¾ To connect the BRI ports: 1. Connect the BRI cable to the device&ap

Seite 15

Installation Manual 22 Document #: LTRT-85605 Mediant 600 Notes: • Damage can be caused to external equipment if PSTN Fallback is activated on

Seite 16 - 2.3.2 19-Inch Rack Mounting

Version 6.0 23 February 2010 Installation Manual 2. Installing the Device ¾ To cable the FXS module's Lifeline: 1. Connect the Lifeline Sp

Seite 17 - 2.4 Cabling the Device

Installation Manual 24 Document #: LTRT-85605 Mediant 600 2.4.9 Connecting to Dry Contact Relay Alarm System The dry contact ports I and II locat

Seite 18 - Protective Earthing

Version 6.0 25 February 2010 Installation Manual 2. Installing the Device ¾ To set up a dry contact system: 1. Insert two wires into the mate’s

Seite 19 - To connect the E1/T1 trunks:

Installation Manual 26 Document #: LTRT-85605 Mediant 600 2.4.11 Connecting to the Power Supply The device receives its power from a standard AC

Seite 20

Version 6.0 27 February 2010 Installation Manual 3. Configuring the Device 3 Configuring the Device This section describes initial, basic setup c

Seite 21 - ¾ To connect the BRI ports:

Installation Manual 28 Document #: LTRT-85605 Mediant 600 3.1.1 Assigning an IP Address using HTTP You can assign an IP address to the device, us

Seite 22

Version 6.0 29 February 2010 Installation Manual 3. Configuring the Device 4. Change the device's IP address, by performing the following:

Seite 23

Version 6.0 3 February 2010 Installation Manual Contents Table of Contents 1 Introduction ...

Seite 24

Installation Manual 30 Document #: LTRT-85605 Mediant 600 8. In the ‘Gateway’ field, enter the IP address of the default gateway (if any). 9. Cl

Seite 25

Version 6.0 31 February 2010 Installation Manual 3. Configuring the Device 3.1.3 Assigning an IP Address using the Voice Menu Guidance Initial c

Seite 26

Installation Manual 32 Document #: LTRT-85605 Mediant 600 ¾ To set a configuration URL: 1. Obtain the IP address of the configuration HTTP serve

Seite 27 - 3 Configuring the Device

Version 6.0 33 February 2010 Installation Manual 3. Configuring the Device The following is an example perl CGI script, suitable for most Apache-

Seite 28

Installation Manual 34 Document #: LTRT-85605 Mediant 600 3.1.4 Assigning an IP Address using the CLI You can assign an IP address to the device,

Seite 29

Version 6.0 35 February 2010 Installation Manual 3. Configuring the Device 3.2 Configuring Basic SIP Parameters Once you have completed the prev

Seite 30

Installation Manual 36 Document #: LTRT-85605 Mediant 600 3.2.1 Enabling Channels and Configuring Call Routing (Example) This section provides an

Seite 31

Version 6.0 37 February 2010 Installation Manual 3. Configuring the Device 2. Configure routing of telephone calls (i.e., Tel or inbound IP) to

Seite 32 - To set a configuration URL:

Installation Manual 38 Document #: LTRT-85605 Mediant 600 3.2.2 Configuring PSTN Trunks This section describes how to configure the configure the

Seite 33

Version 6.0 39 February 2010 Installation Manual 3. Configuring the Device 4. From the ‘Framing Method’ drop-down list, select the required fra

Seite 34

Installation Manual 4 Document #: LTRT-85605 Mediant 600 List of Figures Figure 1-1: Summary of Steps for Installing the Device ...

Seite 35

Installation Manual 40 Document #: LTRT-85605 Mediant 600 3.3 Saving and Resetting the Device To apply configuration changes to the device's

Seite 36

Version 6.0 41 February 2010 Installation Manual 3. Configuring the Device 3.4 Changing Login User Name and Password To prevent unauthorized acc

Seite 37

Installation Manual 42 Document #: LTRT-85605 Mediant 600 3.5 Backing Up and Restoring Configuration You can save a copy/backup of the device&apo

Seite 38 - ¾ To configure the trunks:

Version 6.0 43 February 2010 Installation Manual 3. Configuring the Device 3.6 Restoring Factory Default Settings You can use the device's

Seite 39

Installation Manual 44 Document #: LTRT-85605 Mediant 600 3.7.1 Software Upgrade Wizard The Software Upgrade Wizard allows you to easily upgrade

Seite 40

Version 6.0 45 February 2010 Installation Manual 3. Configuring the Device ¾ To use the Software Upgrade Wizard: 1. Stop all traffic on the dev

Seite 41

Installation Manual 46 Document #: LTRT-85605 Mediant 600 7. You can now choose to either: • Click Reset; the device resets, utilizing the new c

Seite 42

Version 6.0 47 February 2010 Installation Manual 3. Configuring the Device 3.7.2 Loading ini and Auxiliary Files The auxiliary files (and ini fi

Seite 43 - 3.7 Upgrading the Device

Installation Manual 48 Document #: LTRT-85605 Mediant 600 ¾ To load an auxiliary file to the device: 1. Open the 'Load Auxiliary Files&apos

Seite 44

Version 6.0 49 February 2010 Installation Manual 4. Monitoring the Device 4 Monitoring the Device The operating status of the device can be monit

Seite 45

Version 6.0 5 February 2010 Installation Manual Contents List of Tables Table 2-1: Mediant 600 Front Panel Components Description ...

Seite 46

Installation Manual 50 Document #: LTRT-85605 Mediant 600 Table 4-3: BRI I/O Modules LED Description LED Color State Description RJ-45 Green

Seite 47

Version 6.0 51 February 2010 Installation Manual 4. Monitoring the Device ¾ To view a list of current alarms:  In the 'Home' page, c

Seite 48

Installation Manual Version 6.0 www.audiocodes.com

Seite 49 - 4 Monitoring the Device

Installation Manual 6 Document #: LTRT-85605 Mediant 600 Reader’s Notes

Seite 50 - 4.2 Web Interface

Version 6.0 7 February 2010 Installation Manual Notices Notice This Installation Manual describes the hardware installation and quick configurati

Seite 51

Installation Manual 8 Document #: LTRT-85605 Mediant 600 Related Documentation Document Name Product Reference Manual Mediant 600 & Mediant 10

Seite 52

Version 6.0 9 February 2010 Installation Manual 1. Introduction 1 Introduction This manual provides you with step-by-step procedures for initial

Kommentare zu diesen Handbüchern

Keine Kommentare