AudioCodes MP-1FXO Bedienungsanleitung PDF herunterladen (Seite 115)

SIP User's Manual 5. Web Management

Version 5.0 115 December 2006

5.5.7 Configuring the Endpoint Phone Numbers

From the 'Endpoint Phone Number Table' screen you can enable and assign telephone

numbers, hunt groups (optional) and profiles to the VoIP gateway ports.

To configure the Endpoint Phone Number table, take these 4

steps:

1. Open the ‘Endpoint Phone Number Table’ screen (Protocol Management menu >

Endpoint Phone Numbers); the ‘Endpoint Phone Number Table’ screen is displayed.

Figure 5-25: Endpoint Phone Number Table Screen

2. Configure the endpoint phone numbers according to Table 5-25. You must enter a

number in the' Phone Number' fields for each port that you want to use.

3. Click the Submit button to save your changes, or click the Register or Un-Register

buttons to save your changes and to register / unregister to a Proxy / Registrar.

4. To save the changes so they are available after a power fail, refer to Section 5.10.2 on

page 205.

Table 5-25: Endpoint Phone Number Table (continues on pages 115 to 116)

Parameter Description

Channel(s) The numbers (1-8) in the Channel(s) fields represent the ports on the back of the

VoIP gateway.

To enable a VoIP gateway channel, you

must enter the port number on this

screen.

[n-m] represents a range of ports. For example, enter [1-4] to specify the ports

from 1 to 4.

Phone Number In each of the Phone Number fields, enter the telephone number that is assigned

to that channel.

For a range of channels enter the first number in an ordered sequence.

These numbers are also used for port allocation for IP to Tel calls, if the hunt

group’s ‘Channel Select Mode’ is set to ‘By Phone Number’.

1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 389 390

Keine Kommentare

AudioCodes MP-1FXO Bedienungsanleitung Seite 115