AudioCodes Mediant 2000 Installationshandbuch

Document #: LTRT-70113 March 2010 Installation Manual Version 6.0

Installation Manual 10 Document #: LTRT-70113 Mediant 2000 Item # Label Component Description 6 - Reset button. Note: This button is currently r

Version 6.0 11 March 2010 Installation Manual 2. Installing the Device Table 2-2: Rear Panel Component Descriptions Item # Label Component Des

Installation Manual 12 Document #: LTRT-70113 Mediant 2000 2.2 Unpacking and Checking Package Contents Follow the procedure below for unpacking a

Version 6.0 13 March 2010 Installation Manual 2. Installing the Device 2.3 Mounting the Device The device can be mounted in one of the following

Installation Manual 14 Document #: LTRT-70113 Mediant 2000 Warning: When mounting the chassis in a 19-inch rack by attaching it to the rack&apos

Version 6.0 15 March 2010 Installation Manual 2. Installing the Device 2.4 Cabling the Device This section describes the cabling of the device.

Installation Manual 16 Document #: LTRT-70113 Mediant 2000  Cabling for eight trunks and DC power: Figure 2-7: Rear-Panel Cabling for 8 Trunks

Version 6.0 17 March 2010 Installation Manual 2. Installing the Device The 50-pin male Telco cable connector must be wired according to the pinou

Installation Manual 18 Document #: LTRT-70113 Mediant 2000 2.4.3 Connecting the Ethernet Interface The device provides two 10/100Base-TX RJ-45 po

Version 6.0 19 March 2010 Installation Manual 2. Installing the Device 2.4.4 Connecting the Power Supply The connection to the power supply depe

Installation Manual 20 Document #: LTRT-70113 Mediant 2000 ¾ To connect power using a DC terminal block screw connector: 1. Create a DC cable by

Version 6.0 21 March 2010 Installation Manual 2. Installing the Device 2.4.5 Connecting the RS-232 Port to a PC Follow the procedure below to co

Installation Manual 22 Document #: LTRT-70113 Mediant 2000 2.5 Inserting and Extracting Blades The device's 1610 blade (form factor 6U PICMG

Version 6.0 23 March 2010 Installation Manual 3. Configuring the Device 3 Configuring the Device This section describes initial, basic setup conf

Installation Manual 24 Document #: LTRT-70113 Mediant 2000 3.1.1 Assigning an IP Address using HTTP You can assign an IP address to the device, u

Version 6.0 25 March 2010 Installation Manual 3. Configuring the Device 4. Change the device's IP address, by performing the following: a.

Installation Manual 26 Document #: LTRT-70113 Mediant 2000 7. In the ‘Subnet’ field, enter the subnet mask (in dotted-decimal notation) that you

Version 6.0 27 March 2010 Installation Manual 3. Configuring the Device 3.1.3 Assigning an IP Address using the CLI You can assign an IP address

Installation Manual 28 Document #: LTRT-70113 Mediant 2000 3.2 Configuring Basic SIP Parameters Once you have completed the previous sections, yo

Version 6.0 29 March 2010 Installation Manual 3. Configuring the Device 3.2.1 Enabling Channels and Configuring Call Routing (Example) This sect

Version 6.0 3 February 2010 Installation Manual Contents Table of Contents 1 Introduction ...

Installation Manual 30 Document #: LTRT-70113 Mediant 2000 3.2.2 Configuring PSTN Trunks This section describes how to configure the configure th

Version 6.0 31 March 2010 Installation Manual 3. Configuring the Device 5. From the ‘Clock Master’ drop-down list, select the trunk's clock

Installation Manual 32 Document #: LTRT-70113 Mediant 2000 3.3 Saving and Resetting the Device To apply configuration changes to the device'

Version 6.0 33 March 2010 Installation Manual 3. Configuring the Device 3.4 Changing Login User Name and Password To prevent unauthorized access

Installation Manual 34 Document #: LTRT-70113 Mediant 2000 3.5 Backing Up and Restoring Configuration You can save a copy/backup of the device&ap

Version 6.0 35 March 2010 Installation Manual 3. Configuring the Device 3.6 Upgrading the Device You can upgrade the device with the following f

Installation Manual 36 Document #: LTRT-70113 Mediant 2000 ¾ To use the Software Upgrade Wizard: 1. Stop all traffic on the device (refer to the

Version 6.0 37 March 2010 Installation Manual 3. Configuring the Device 4. Click the Browse button, navigate to the cmp file, and then click Se

Installation Manual 38 Document #: LTRT-70113 Mediant 2000 3.6.2 Loading ini and Auxiliary Files The auxiliary files (and ini file) are dat fil

Version 6.0 39 March 2010 Installation Manual 3. Configuring the Device 2. Click the Browse button corresponding to the file type that you want

Installation Manual 4 Document #: LTRT-70113 Mediant 2000 List of Figures Figure 1-1: Summary of Steps for Installing the Device ...

Installation Manual 40 Document #: LTRT-70113 Mediant 2000 Reader’s Notes

Version 6.0 41 March 2010 Installation Manual 4. Monitoring the Device 4 Monitoring the Device The operating status of the device can be monitore

Installation Manual 42 Document #: LTRT-70113 Mediant 2000 Note: On the front panel, 16 LEDs are provided for 16-span units and 8 LEDs are pro

Version 6.0 43 March 2010 Installation Manual 4. Monitoring the Device • Source: element from which the alarm was generated • Description: brie

Installation Manual Version 6.0 www.audiocodes.com

Version 6.0 5 March 2010 Installation Manual Notices Notice This Installation Manual describes the hardware installation and quick configuration

Installation Manual 6 Document #: LTRT-70113 Mediant 2000 Related Documentation Manual Name Product Reference Manual Mediant 2000 and Mediant 300

Version 6.0 7 March 2010 Installation Manual 1. Introduction 1 Introduction This manual provides you with step-by-step procedures for initial and

Installation Manual 8 Document #: LTRT-70113 Mediant 2000 Reader’s Notes

Version 6.0 9 March 2010 Installation Manual 2. Installing the Device 2 Installing the Device This section describes the device's hardware