AudioCodes MP-204B Bedienungsanleitung PDF herunterladen (Seite 2)

Overview of Procedure

The M1K must be connected to the internal LAN (a 100 Mbps connection is recommended) and 1 to 8

trunks.

The MP-11x has two configuration options: webpage or configuration file. For convenience, this

document describes configuration using the gateway’s webpage. This has the advantage of providing

familiarity with using the web page, which will most likely be used later for making minor changes in the

gateway configuration. It has the disadvantage that an inadvertent change to one of the many parameters

may cause problems. For this reason it is recommended that you make only the changes described below

to a factory reset gateway. After the gateway is operational, further changes can be made as required.

The basic steps for installation and configuration are:

1. Unpack the MP-11x.

2. Mount the MP-11x.

3. Connect cables.

4. Set the IP address and subnet mask of the gateway through the serial port on MP-11x.

5. Access the MP-11x web page.

6. Configure the gateway.

7. Save the configuration and reboot the MP-11x.

8. Back up the configuration.

Steps 1 through 3 are standard for any gateway. Please follow the instructions provided by AudioCodes

for the gateway. This document is intended to be a companion document to the AudioCodes documents.

Use both while configuring the gateway.

The rest of this section details Steps 4 and 8 to configure the MP-11x for operation with the UC server.

Configuring the Gateway

Software Level

This document is based on the gateway software from the last interoperability testing conducted by

ADTRAN. If the software revision does not match, contact the manufacturer’s website for the version

that is shown below. Failure to do so may result in unexpected behavior.

1 2 3 4 5 6 7 ... 10 11

Keine Kommentare

AudioCodes MP-204B Bedienungsanleitung Seite 2