AudioCodes MP-204B Bedienungsanleitung PDF herunterladen (Seite 7)

See Figure 6 below.

Figure 6 – With these settings any incoming call is routed to 10000.

Outgoing

A gateway may have more physical trunks than are being used at a site. When an outgoing call is being

made to the PSTN it is important that the gateway not choose a trunk that is not there or not in service.

Enable only those trunks that are actually in use.

If an operational trunk is busy, the gateway must ‘hunt’ for a free trunk to complete the call. Configure a

trunk group that specifies which trunks are to be used for outgoing calls and what the hunting algorithm

should be, for example, ascending or descending.

1. Go to Protocol Management -> Endpoint Phone Numbers.

2. Assign each trunk the same Hunt Group ID.

See Figure 7 below.

Figure 7 – The important thing here is the Hunt Group ID.

3. Go to Protocol Management -> Hunt Group Settings.

4. For the Hunt Group ID chosen select an appropriate Channel Select Mode.

1 2 3 4 5 6 7 8 9 10 11

Keine Kommentare

AudioCodes MP-204B Bedienungsanleitung Seite 7