AudioCodes MP-102 Installationsanleitung PDF herunterladen (Seite 28)

MP-1xx

MP-1xx 26 Document #: LTRT-61406

Note: The following Sections from here, up to the end of this Fast Track Guide,

apply equally to MGCP, H.323 and SIP.

4 Changing the MP-1xx Username and

Password

To prevent unauthorized access to the Embedded Web Server, two levels of security are

available: Administrator and Monitoring. Each employs a different username and password.

Users can access the Embedded Web Server as either:

• Administrator - all Web screens are read-write and can be modified (default username

‘Admin’, default password ‘Admin’).

• Monitoring - all Web screens are read-only and cannot be modified. In addition, the following

screens cannot be accessed: ’Reset‘, ‘Save Configuration‘, ‘Software Upgrade Wizard’,

‘Load Auxiliary Files’, ‘Configuration File’ and ‘Regional Settings’. The ’Change Password‘

screen can only be used to change the monitoring password (default username ‘User’,

default password ‘User’).

It is recommended that you change the default username and password of the security mode you

use to access the Embedded Web Server.

¾ To change the username and password, take these 5 step:

1. Access the Embedded Web Server (refer to Section 3.3 on page 19).

2. Open the ‘Change Password’ screen (Advanced Configuration menu > Change

Password

); the ‘Change Password’ screen is displayed.

Figure 4-1: Change Password Screen in Administrator Mode

3. In the ‘User Name’ and ‘New Password’ fields, enter the new username and the new

password respectively. Note that the username and password of both levels can be a

maximum of 19 case-sensitive characters.

4. In the ‘Confirm Password’ field, reenter the new password.

5. To apply the new username and password to the Administrator level:

Click the button

Change Administrator Password; the new username and password are

applied and the ‘Enter Network Password’ screen appears, shown in Figure

3-2. Enter the

updated username and password in the ‘Enter Network Password’ screen.

To apply the new username and password to the Monitoring level:

Click the button

Change Monitoring Password; the new username and password are

applied.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 43 44

Keine Kommentare

AudioCodes MP-102 Installationsanleitung Seite 28