AudioCodes MP-102 Installationsanleitung PDF herunterladen (Seite 17)

Fast Track Installation Guide 3. Configuring the MP-1xx

Version 4.6 15 July 2005

3 Configuring the MP-1xx

The MP-1xx is supplied with application software already resident in its flash memory (with

factory default parameters).

Section

3.1 below describes how to assign an IP address to the MP-1xx, while Section 3.4 on

page 19 describes how to set up the MP-1xx with basic parameters using a standard Web

browser (such as Microsoft

Internet Explorer).

Note: Section 3.1 applies equally to MGCP, H.323 and SIP.

3.1 Assigning the MP-1xx IP Address

To assign an IP address to the MP-1xx use one of the following methods:

• HTTP using a Web browser (refer to Section

3.1.1 below).

• BootP (refer to Section

3.1.2 on page 16).

• DHCP (refer to the MP-1xx User’s Manual).

• The embedded Command Line Interface (CLI) accessed via Telnet or RS-232 (refer to

Section

3.1.3 on page 17).

The default networking parameters are show in Table

3-1.

Use the ‘Reset’ button at any time to restore the MP-1xx networking parameters to their factory

default values (refer to Section

3.2 on page 18).

Table

3-1: MP-1xx Default Networking Parameters

FXS or FXO Default Value

FXS

10.1.10.10

FXO

10.1.10.11

MP-1xx default subnet mask is 255.255.0.0, default gateway IP address is 0.0.0.0

3.1.1 Assigning an IP Address Using HTTP

¾ To assign an IP address using HTTP, take these 8 steps:

1. Disconnect the MP-1xx from the network and reconnect it to your computer using one of the

following two methods:

¾ Use a standard Ethernet cable to connect the network interface on your computer to a

port on a network hub / switch. Use a second standard Ethernet cable to connect the

MP-1xx to another port on the same network hub / switch.

¾ Use an Ethernet cross-over cable to directly connect the network interface on your

computer to the MP-1xx.

2. Change your PC’s IP address and subnet mask to correspond with the MP-1xx factory

default IP address and subnet mask, shown in Table

3-1. For details on changing the IP

address and subnet mask of your PC, refer to Windows™ Online Help (Start>Help).

3. Access the MP-1xx Embedded Web Server (refer to Section

3.3 on page 19).

4. In the ‘Quick Setup’ screen, set the MP-1xx ‘IP Address’, ‘Subnet Mask’ and ‘Default

Gateway IP Address’ fields under ‘IP Configuration’ to correspond with your network IP

settings. If your network doesn’t feature a default gateway, enter a dummy value in the

‘Default Gateway IP Address’ field.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 43 44

Kommentare zu diesen Handbüchern

Keine Kommentare

AudioCodes MP-102 Installationsanleitung Seite 17

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Gateways / Controller AudioCodes MP-102