AudioCodes MP-102 Installationsanleitung PDF herunterladen (Seite 19)

Fast Track Installation Guide 3. Configuring the MP-1xx

Version 4.6 17 July 2005

12. Use the reset button (located on the MP-1xx front panel) to physically reset the gateway

causing it to use BootP; the MP-1xx changes its network parameters to the values provided

by the BootP.

Figure

3-1: Client Configuration Screen with Blank Parameters

3.1.3 Assigning an IP Address Using the CLI

First access the CLI using a standard Telnet application or using a serial communication software

(e.g., HyperTerminal

) connected to the MP-1xx RS-232 port (refer to Section 3.1.3.1 below).

Then assign the MP-1xx an IP address (refer to Section

3.1.3.2 on page 18).

3.1.3.1 Access the CLI

¾ To access the CLI via the Embedded Telnet Server, take these 3 steps:

1. Enable the Embedded Telnet Server:

¾ Access the MP-1xx Embedded Web Server (refer to Section

3.3 on page 19).

¾ Set the parameter ‘Embedded Telnet Server’ (under Advanced Configuration >

Network Settings > Application Settings) to ‘Enable (Unsecured)’.

¾ Click the Reset button on the main menu bar; the Reset screen is displayed.

¾ Click the Reset button in the middle of the Reset screen with the Burn option selected;

the MP-1xx is shut down and re-activated. A message about the waiting period is

displayed. The screen is refreshed.

2. Use a standard Telnet application to connect to the MP-1xx Embedded Telnet Server.

3. Login using the username (‘Admin’) and password (‘Admin’).

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 43 44

Keine Kommentare

AudioCodes MP-102 Installationsanleitung Seite 19