AudioCodes MP-102 Installationsanleitung PDF herunterladen (Seite 23)

Fast Track Installation Guide 3. Configuring the MP-1xx

Version 4.6 21 July 2005

8. In the ‘Endpoint Name’ field, enter an intuitive endpoint name. Ensure that the endpoint

name you choose is the one that the Call Agent works with.

9. In the ‘Endpoint Numbering Offset’ field, you can enter a value to offset the numbers that

represent the gateway’s endpoints.

10. Click the Reset button and click OK in the prompt; The MP-1xx applies the changes and

restarts. This takes approximately 1 minute to complete. When the MP-1xx has finished

restarting, the Ready and LAN LEDs on the front panel are lit green.

Note: MGCP users should continue with Section 4 Changing the MP-1xx Username

on page 26.

3.4.2 Configuring Basic H.323 Parameters

After accessing the Embedded Web Server (refer to Section 3.3 on page 19) the H.323 ‘Quick

Setup’ screen is displayed, shown in Figure

3-4.

Figure

3-4: MP-1xx H.323 Quick Setup Screen

¾ To configure basic H.323 parameters, take these 7 steps:

1. If the MP-1xx is connected to a router with NAT enabled, perform the following procedure. If

it isn’t, leave the ‘NAT IP Address’ field undefined.

¾ Determine the “public” IP address assigned to the router (by using, for instance, router

Web management). Enter this public IP address in the ‘NAT IP Address’ field.

¾ Enable the DMZ configuration on the residential router for the LAN port where the MP-

1xx gateway is connected. This enables unknown packets to be routed to the DMZ port.

2. When working with a Gatekeeper, under ‘H.323 Parameters’, set ‘Working with Gatekeeper’

field to ‘Yes’ and enter the IP address of the primary Gatekeeper in the field ‘Gatekeeper IP

Address’. When no Gatekeeper is used, the internal routing table is used to route the calls.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 43 44

Keine Kommentare

AudioCodes MP-102 Installationsanleitung Seite 23