AudioCodes MP-102 Installationsanleitung PDF herunterladen (Seite 32)

MP-1xx

MP-1xx 30 Document #: LTRT-61406

7 Upgrading the MP-1xx

The ‘Software Update’ menu enables users to upgrade the MP-1xx software by loading a new

cmp file along with the ini and a suite of auxiliary files, or to update the existing auxiliary files.

The ‘Software Update’ menu comprises two submenus:

• Software Update Wizard (refer to Section

7.1 below).

• Auxiliary Files (refer to Section

7.2 on page 34).

Note: When upgrading the MP-1xx software you must load the new cmp file with all

other related configuration files.

7.1 Software Upgrade Wizard

The Software Upgrade Wizard guides users through the process of software upgrade: selecting

files and loading them to the gateway. The wizard also enables users to upgrade software while

maintaining the existing configuration. Using the wizard obligates users to load a cmp file. Users

can choose to also use the Wizard to load the ini and auxiliary files (e.g., Call Progress Tones)

but this option cannot be pursued without loading the cmp file. For the ini and each auxiliary file

type, users can choose to reload an existing file, load a new file or not load a file at all.

Warning 1: The Software Upgrade Wizard requires the MP-1xx to be reset at the end

of the process, disrupting any of its traffic. To avoid disruption, disable all

traffic on the MP-1xx before initiating the Wizard.

Warning 2: Verify, prior to clicking the Start Software Upgrade button that no traffic is

running on the device. After clicking this button a device reset is

mandatory. Even if you choose to cancel the process in the middle, the

device resets itself and the previous configuration burned to flash is

reloaded.

¾ To use the Software Upgrade Wizard, take these 9 steps:

1. Stop all traffic on the MP-1xx (refer to the note above).

2. Open the ‘Software Upgrade Wizard’ (Software Update menu > Software Upgrade

Wizard

); the ‘Start Software Upgrade’ screen appears.

Figure 7-1: Start Software Upgrade Screen

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 43 44

Keine Kommentare

AudioCodes MP-102 Installationsanleitung Seite 32