AudioCodes MP-102 Installationsanleitung PDF herunterladen (Seite 24)

MP-1xx

MP-1xx 22 Document #: LTRT-61406

3. Leave parameter ‘Enable Annex D/T.38 FAX Relay’ at its default unless your technical

requirements differ.

4. Select the coder (i.e., vocoder) that best suits your VoIP system requirements. The default

coder is: G.7231 30 msec. To program the entire list of coders you want the MP-1xx to use,

click the button on the left side of the ‘1

Coder’ field; the drop-down list for the 2

to 5

coders appear. Select coders according to your system requirements. Note that coders

higher on the list are preferred and take precedence over coders lower on the list.

Note: The preferred coder is the coder that the MP-1xx uses as a first choice for all

connections. If the far end gateway does not use this coder, the MP-1xx

negotiates with the far end gateway to select a coder that both sides can use.

5. Map outgoing calls to IP addresses (when Gatekeeper isn’t used) by completing these steps:

¾ Click the arrow button next to the ‘Tel to IP Routing Table’ label; the ‘Tel to IP Routing’

screen opens.

Any telephone number whose destination number matches the prefix defined in the

‘Destination Phone Prefix’ field and whose source number matches the prefix defined in

the adjacent ‘Source Phone Prefix‘ field, is sent to the IP address entered in the ‘IP

Address’ field.

¾ Click the Submit button; the ‘Tel to IP Routing’ table is automatically updated.

¾ Click Quick Setup; you’re returned to the ‘Quick Setup’ screen.

For more information on the ‘Tel to IP Routing’ table refer to the MP-1xx H.323 User’s

Manual.

6. Allocate MP-1xx endpoints (analog lines) and their corresponding phone numbers to

incoming IP calls by completing these steps:

¾ Click the arrow button next to the ‘Endpoint Phone Number’ label; the ‘Endpoint Phone

Numbers’ screen opens.

¾ Enter the number of a channel, starting with 1, (or a group of channels), under the

column ‘Channel(s)’ (for example 1-4 for the first 4 endpoints).

¾ Assign each channel a phone number (for a group of channels, define the first number

in an ordered sequence). For an example of connecting two MP-108 devices, refer to

Section

3.4.4 on page 25.

¾ Click the Submit button; the ‘Endpoint Phone Number’ table is automatically updated.

¾ Click Quick Setup; you’re returned to the ‘Quick Setup’ screen.

7. Click the Reset button and click OK in the prompt; The MP-1xx applies the changes and

restarts. This takes approximately 1 minute to complete. When the MP-1xx has finished

restarting, the Ready and LAN LEDs on the front panel are lit green.

Note: H.323 users should continue with Section 3.4.4 Example of Connecting Two

MP-108 Devices on page 25.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 43 44

Keine Kommentare

AudioCodes MP-102 Installationsanleitung Seite 24