AudioCodes Mediant 1000 Bedienungsanleitung PDF herunterladen (Seite 21)

SIP SOLUTIONS TRUNKING

Configuration Settings, Notes, & Recommendations

Page 20

March 2012

Not modified or used in this configuration.

This section contains 53 different parameters. Fortunately, the majority are left at their default

values or do not apply to the certified configuration. It is important to ensure the values shown in

the three screen captures below as configured properly.

The following parameters are noted for close inspection and provisioning. PRACK Mode is set

to ‘Enable.’ Enable Early Media is set to ‘Enable.’ SIP UDP Port value is configured to ‘5060.’

The SIP Destination Port is also configured to ‘5060.’ Ringback Tone to IP is set to ‘Don’t Play.’

Ringback Tone to Tel is set to ‘Play Local Until Remote Media Arrives.’

Note that Fax support is disabled. It is a discretionary parameter than must be configured as

desired.

CONTROL NETWORK

VOIP

NAT Translation Table

SIP DEFINITIONS

VOIP

General Parameters

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 45 46

Keine Kommentare

AudioCodes Mediant 1000 Bedienungsanleitung Seite 21