AudioCodes MediaPack MP-124 Bedienungsanleitung PDF herunterladen (Seite 43)

Configuration Note 4. Configuring the Device

Version 6.6 43 September 2013

4.9 Step 9: Configuring IP Media

This step shows how to configure the number of media channels for IP-based media. To

perform coder transcoding, define digital signaling processors (DSP) channels. The

number of media channels represents the number of DSP channels that the SBC entity

allocates to sessions.

Note: This step is required only if transcoding is required.

 To configure IP media:

1. Open the IP Media Settings page (Configuration tab > VoIP > IP Media > IP Media

Settings).

Figure 4-22: IP Media Settings

2. In the 'Number of Media Channels' field, enter the number of media channels

according to your environment's transcoding calls (e.g., 30).

3. Click Submit.

4. Reset the device with a burn to flash for this setting to take effect (see Section 4.16

on page 70).

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 97 98

Keine Kommentare

AudioCodes MediaPack MP-124 Bedienungsanleitung Seite 43