AudioCodes Mediant 3000 Bedienungsanleitung PDF herunterladen (Seite 67)

Configuration Note 4. Configuring AudioCodes E-SBC

Connecting Microsoft Lync 2013 to a SIP Trunk 67 June 2013

4.12 Step 12: Configuring IP-to-IP Outbound Manipulation

This step shows how to configure IP-to-IP manipulation rules. They concern number

manipulation of the source and / or destination number. They use IP Groups to denote the

source and destination of the call. As configured in Step 5 (see Section 4.5 on page 47), IP

Group ID 1 was assigned to Lync Server 2013 and IP Group ID 2 to the SIP Trunk.

Note: Adapt the manipulation table according to you environment dial plan.

The step below exemplifies configuring a manipulation rule which adds a plus sign + to the

destination number for calls from IP Group 2 (SIP Trunk) destined to IP Group 1 (i.e., Lync

Server 2013), when the destination number prefix is any number (*).

 To add a number manipulation rule:

1. Open the IP to IP Outbound Manipulation page (Configuration tab > VoIP > SBC >

Manipulation SBC > IP to IP Outbound).

2. Click Add.

3. Click the Rule tab and configure the parameters like this:

Parameter Example Setting

Index "1"

Source IP Group "2"

Destination IP Group "1"

Destination Username Prefix "*"

Manipulated URI

Destination

Figure 4-34: IP-to-IP Outbound Manipulation Rule – Rule Tab

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 79 80

Keine Kommentare

AudioCodes Mediant 3000 Bedienungsanleitung Seite 67