AudioCodes MediaPack 114 Bedienungsanleitung PDF herunterladen (Seite 134)

SIP User's Manual 134 Document #: LTRT-65411

MediaPack Series

Parameter Description

Silence Detection Period

[sec]

[FarEndDisconnectSile

ncePeriod]

Duration of silence period (in seconds) prior to call disconnection.

The range is 10 to 28,800 (i.e., 8 hours). The default is 120 seconds.

Silence Detection

Method

[FarEndDisconnectSile

nceMethod]

Silence detection method.

 [0] None = Silence detection option is disabled.

 [1] Packets Count = According to packet count.

 [2] Voice/Energy Detectors = According to energy and voice detectors

(default).

 [3] All = According to packet count, and energy and voice detectors.

Enable Fax Re-Routing

[EnableFaxReRouting]

Enables or disables re-routing of Tel-to-IP calls that are identified as fax

calls.

 [0] Disable = Disabled (default).

 [1] Enable = Enabled.

If a CNG tone is detected on the Tel side of a Tel-to-IP call, a 'FAX' prefix

is appended to the destination number before routing and manipulations.

An entry of ‘FAX’ as destination number in the 'Tel-to-IP Routing' table is

then used to route the call, and the destination number manipulation

mechanism is used to remove the 'FAX' prefix, if required.

If the initial INVITE used to establish the voice call (not fax) was already

sent, a CANCEL (if not connected yet) or a BYE (if already connected) is

sent to tear down the voice call.

Notes:

 To enable this feature, set CNGDetectorMode to 2, and IsFaxUsed to

1, 2, or 3.

 The 'FAX' prefix in routing and manipulation tables is case sensitive.

CDR and Debug

CDR Server IP Address

[CDRSyslogServerIP]

Defines the destination IP address to where CDR logs are sent.

The default value is a null string, which causes CDR messages to be sent

with all Syslog messages to the Syslog server.

Note: The CDR messages are sent to UDP port 514 (default Syslog

port).

CDR Report Level

[CDRReportLevel]

Determines whether Call Detail Records (CDR) are sent to the Syslog

server and when they are sent.

 [0] None = CDRs are not used (default).

 [1] End Call = CDR is sent to the Syslog server at the end of each call.

 [2] Start & End Call = CDR report is sent to Syslog at the start and

end of each call.

 [3] Connect & End Call = CDR report is sent to Syslog at connection

and at the end of each call.

 [4] Start & Connect & End Call = CDR report is sent to Syslog at the

start, at connection, and at the end of each call.

The CDR Syslog message complies with RFC 3161 and is identified by:

Facility = 17 (local1) and Severity = 6 (Informational).

Debug Level

[GwDebugLevel]

Syslog debug logging level.

 [0] 0 = Debug is disabled (default).

1 2 ... 129 130 131 132 133 134 135 136 137 138 139 ... 389 390

Kommentare zu diesen Handbüchern

Keine Kommentare

AudioCodes MediaPack 114 Bedienungsanleitung Seite 134

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Gateways / Controller AudioCodes MediaPack 114