AudioCodes MediaPack 114 Bedienungsanleitung PDF herunterladen (Seite 145)

Version 5.6 145 November 2008

SIP User's Manual 3. Web-Based Management

¾ To configure the Metering tones, take these 4 steps:

1. Open the 'Metering Tones' page (Configuration tab > Protocol Configuration menu

> SIP Advanced Parameters submenu > Metering Tones page item).

Figure 3-64: Metering Tones Page

2. Configure the Metering tones parameters according to the table below.

3. Click the Submit button to save your changes.

4. To save the changes to the flash memory, refer to ''Saving Configuration'' on page

209.

Note: In the 'Tel to IP Routing' table (refer to ''Tel to IP Routing Table'' on page 160),

assign a charge code rule to the routing rules you require. When a new call is

established, the 'Tel to IP Routing' table is searched for the destination IP

addresses. Once a route is found, the Charge Code (configured for that route)

is used to associate the route with an entry in the 'Charge Codes' table.

Table 3-34: Metering Tones Parameters

Parameter Description

Generate Metering Tones

[PayPhoneMeteringMode]

Determines the method used to configure the metering tones that are

generated to the Tel side.

 [0] Disable = Metering tones aren't generated (default).

 [1] Internal Table = Metering tones are generated according to the

internal table configured by the parameter ChargeCode.

Notes:

 This parameter is applicable only to FXS interfaces.

 If you select 'Internal Table', you must configure the 'Charge Codes

Table' (refer to ''Charge Codes Table'' on page 146).

Metering Tone Type

[MeteringType]

Defines the metering tone (12 or 16 kHz) that is generated by FXS

interfaces.

 [0] 12 kHz = 12-kHz metering tone (default).

 [1] 16 kHz = 16-kHz metering tone.

Note: A suitable (12 or 16 KHz) FXS Coefficient file must be used for

FXS interfaces.

Charge Codes Table If you configured the 'Generate Metering Tones' parameter to 'Internal

Table', access the 'Charge Codes Table' page, by clicking

. For

detailed information on configuring the Charge Codes table, refer to

''Charge Codes Table'' on page 146.

1 2 ... 140 141 142 143 144 145 146 147 148 149 150 ... 389 390

Keine Kommentare

AudioCodes MediaPack 114 Bedienungsanleitung Seite 145