AudioCodes MediaPack 114 Bedienungsanleitung PDF herunterladen (Seite 182)

SIP User's Manual 182 Document #: LTRT-65411

MediaPack Series

Figure 3-85: Endpoint Phone Number Table Page

2. Configure the endpoint phone numbers according to the table below. You must enter a

number in the 'Phone Number' fields for each port that you want to use.

3. Click the Submit button to save your changes, or click the Register or Un-Register

buttons to save your changes and to register / unregister to a Proxy / Registrar.

4. To save the changes to the flash memory, refer to ''Saving Configuration'' on page

209.

Table 3-45:

Endpoint Phone Number Table Description

Parameter Description

Channel(s)

The port numbers (channels / endpoints) as labeled on the device's rear-panel. To

enable a device channel, you must enter the port (channel) number. You can

enter a range of ports using the format [n-m], where n represents the lower port

number and m the higher port number. For example, [1-4] specifies ports 1

through 4.

Phone Number

The telephone number that is assigned to the channel. For a range of channels,

only enter the first telephone number. Subsequent channels are assigned the next

consecutive telephone number. For example, if you enter 400 for channels 1 to 4,

then channel 1 is assigned phone number 400, channel 2 is assigned phone

number 401, and so on.

These numbers are also used for port allocation for IP-to-Tel calls if the Hunt

Group’s ‘Channel Select Mode’ is set to ‘By Phone Number’.

Note: If the 'Phone Number' field includes alphabetical characters and the phone

number is defined for a range of channels (e.g., 1-4), then the phone number

must end with a number (e.g., 'user1').

Hunt Group ID

The Hunt Group ID (1-99) optionally assigned to the channel(s). The same Hunt

Group ID can be assigned to multiple channels. The Hunt Group ID defines a

group of common channel behavior for routing IP-to-Tel calls. If an IP-to-Tel call is

assigned to a Hunt Group, the call is routed to the channel(s) that are assigned to

the same Hunt Group ID.

You can also configure the 'Hunt Group Settings' table (refer to ''Configuring the

Trunk Group Settings'' on page 183) to

determine the method in which new calls

are assigned to channels within the Hunt Groups

Note: If you enter a Hunt Group ID, you must configure the 'IP to Hunt Group

Routing Table' page (refer to “IP to Hunt Group Routing”), which assigns incoming

IP calls to the appropriate Hunt Group. If you do not configure the 'IP to Hunt

Group Routing Table', calls are not established.

Profile ID

The Tel Profile ID (refer to ''Tel Profile Settings'' on page 171) assig

ned to the

endpoint(s).

1 2 ... 177 178 179 180 181 182 183 184 185 186 187 ... 389 390

Kommentare zu diesen Handbüchern

Keine Kommentare

AudioCodes MediaPack 114 Bedienungsanleitung Seite 182

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Gateways / Controller AudioCodes MediaPack 114