
Version 5.6 185 November 2008
SIP User's Manual 3. Web-Based Management
Parameter Description
endpoints from being registered by assigning them to a Hunt
Group and configuring the Hunt Group registration mode to
'Don't Register'.
[5] Per Account = Registrations are sent (or not) to an IP
Group, according to the settings in the Account table (refer
to ''Configuring the Account Table'' on page 188).
Notes:
To enable Hunt Group registrations, configure the global
parameter IsRegisterNeeded to 1. This is unnecessary for
'Per Account' registration mode.
If no mode is selected, the registration is performed
according to the global registration parameter
ChannelSelectMode (refer to ''Proxy & Registration
Parameters'' on page 112).
If the device is configured globally (ChannelSelectMode) to
register Per Endpoint, and a Hunt Group comprising four
FXO endpoints is configured to register Per Gateway, the
device registers all endpoints except the first four endpoints.
The Hunt Group of these four endpoints sends a single
registration request.
Serving IP Group ID
[TrunkGroupSettings_ServingIP
Group]
The Serving IP Group ID to where INVITE messages initiated
by this Hunt Group's endpoints are sent. The actual destination
to where these INVITE messages are sent is to the Proxy Set
ID (refer to ''Proxy Sets Table'' on page 120) a
ssociated with
this Serving IP Group. The Request URI hostname in the
INVITE and REGISTER messages (except for 'Per Account'
registration modes) is set to the value of the field 'SIP Group
Name' defined in the 'IP Group' table (refer to ''Configuring the
IP Groups'' on page 186).
If no Serving IP Group ID is selected, the INVITE messages are
sent to the default Proxy or according to the 'Tel to IP Routing
Table' (refer to ''Tel to IP Routing Table'' on page 160) .
Not
e: If the parameter PreferRouteTable is set to 1 (refer to
''Proxy & Registration Parameters'' on page 112), the
routing
rules in the 'Tel to IP Routing Table' prevail over the selected
Serving IP Group ID.
Gateway Name
[TrunkGroupSettings_GatewayN
ame]
The host name used in the From header in INVITE messages,
and as a host name in From/To headers in REGISTER
requests. If not configured, the global parameter
SIPGatewayName is used instead.
Contact User
[TrunkGroupSettings_ContactU
ser]
This is used as the user part in the Contact URI in INVITE
messages, and as a user part in From, To, and Contact headers
in REGISTER requests. This is applicable only if the field
'Registration Mode' is set to 'Per Account', and the Registration
through the Account table is successful.
Notes:
If registration fails, then the userpart in the INVITE Contact
header contains the source party number.
The 'ContactUser' parameter in the 'Account Table' page
overrides this parameter.
Kommentare zu diesen Handbüchern